Cảm biến tiệm cận Omron E2E-X20MD1S-M1

Thông số kỹ thuật cảm biến tiệm cận Omron E2E-X20MD1S-M1

• Form of output switching element: Normally open (NO)
• Size Ø: M30
• Shielded: Unshielded
• AC/DC Wire: DC 2-Wire
• Sensing distance: 20 mm ±10%
• Set distance *1: 0 to 16 mm
• Differential travel: 10% max. of sensing distance
• Detectable object: Ferrous metal (The sensing distance decreases with non-ferrous metal. Refer to Engineering Data on Data Sheet.)
• Standard sensing object: Iron, 54 × 54 × 1 mm
• Response frequency *2: 0.1 kHz
• Power supply voltage (operating voltage range): 12 to 24 VDC, ripple (p-p): 10% max. (10 to 30 VDC)
• Leakage current: 0.8 mA max.
• Control output Load current: 3 to 100 mA, Diagnostic output: 50 mA for -D1(5)S Models
• Control output Residual voltage: 3 V max. (Load current: 100 mA, Cable length: 2 m)
• Indicators: D1 Models: Operation indicator (red) and setting indicator (green)
  D2 Models: Operation indicator (red)
• Operation mode (with sensing object approaching): D1 Models: NO
  D2 Models: NC
  Refer to the timing charts under I/O Circuit Diagrams on Data Sheet for details.
• Protection circuits: Surge suppressor, Load short-circuit protection (for control and diagnostic output)
• Ambient temperature: Operating: -25 to 70°C, Storage: -40 to 85°C (with no icing or condensation)
• Ambient humidity range: Operating/storage: 35% to 95% (with no condensation)
• Temperature influence: ±10% max. of sensing distance at 23°C in the temperature range of -25 to 70°C
  ±1% max. of sensing distance at rated voltage in the rated voltage ±15% range
• Voltage influence: ±1% max. of sensing distance at rated voltage in the rated voltage ±15% range
• Insulation resistance: 50 MΩ min. (at 500 VDC) between current-carrying parts and case
• Dielectric strength: 1000 VAC, 50/60 Hz for 1 minute between current carry parts and case
• Vibration resistance: Destruction: 10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z
• Shock resistance: Destruction: 1,000 m/s2 10 times each in X, Y, and Z directions
• Degree of protection: Pre-wired Models: IEC 60529 IP67, in-house standards: oil-resistant Connector Models: IEC 60529 IP67
  Pre-wired Models (Standard cable length: 2 m), Connector Models, or Pre-wired
  Connector Models (Standard cable length: 0.3 m)
• Connection method: Pre-wired Models (Standard cable length: 2 m), Connector Models, or Pre-wired Connector Models (Standard cable length: 0.3 m)
• Weight (packed state): Approx. 175 g
• Materials Case: Nickel-plated brass
• Materials Sensing surface: PBT
• Materials Clamping nuts: Nickel-plated brass
• Materials Toothed washer: Zinc-plated iron
• Accessories: Instruction manual